9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12
OPERA
TOR’S MANU
AL ECOS 7000
14
PRESSURE WASHER INSTRUCTIONS
STEP 1: Read safety, installation
and preventative maintenance in-
structions before starting machine.
Fill the water tanks from a clean wa-
ter source. If filling from a hydrant,
flush out any rust before connecting
water supply. The water supply may
remain connected for further filling.
Tanks can also be filled by remov-
ing lid and feeding water directly
into tanks.
CAUTION: To prevent damage to
the pump, incoming water tem-
perature must not exceed 140° F.
STEP 5: Pull wand coupler collar
back and insert desired pressure
nozzle into wand coupler. Then
secure by pushing coupler collar
forward.
CAUTION: Never replace nozzles
without engaging the safety latch
on the spray gun trigger.
STEP 6: For hot water, turn
the burner switch to ON and set
the thermostat knob to the desired
temperature. When a steady stream
of water flows out of the spray gun
the burner will light automatically.
NOTE: Do not star t machine
with burner switch on. The green
light will be illuminated when the
burner switch is in the on position.
98013160-11
98013160-12
3
2
1
VACUUM
RECLAIM
BURNE
R
PUMP
ON
OF
F
POWE
R
SenDEC
TACH/
HOU
R
1/1
0
98013160-13
STEP 3: Read engine manual pro-
vided and pull choke. Pull spray gun
trigger to relieve pressure. Turn the
engine switch to the START posi-
tion and hold until the engine starts.
NOTE: Do not engage the
electric starter for more than five
seconds at a time. If the engine
fails to start, release the switch, pull
spray gun trigger and wait ten sec-
onds before operating the starter
again. Once the engine starts, push
the choke in.
R
ON
POWE
R
HOURS
CHOK
E
9.807-3
56.
0
SenDEC
TAC
H/HOU
R
1/10
98013160-14
98013160-15
STEP 4: With the spray nozzle
pointed away from you or anybody
else, press the trigger on the spray
gun to obtain pressurized cold water
spray.
98013160-30
ON
OFF
ON
OFF
INNER VALVE
OUTER VALVE
Step 2: To fill the two outer tanks,
turn the inner tank valve to the "OFF"
position and the outer tank valve to
the "ON" position. To fill all four tanks
turn the two bottom valves to the
"ON" position. The two outer tanks
are linked together with a 1" line to
distribute the weight of the water.
The two inner tanks are also linked
together
