23
2. Installation
2.1.
Tools Needed
• Socket set with 3/8" socket, 1/2" socket, and 9/16" socket
• Open end wrenches 14mm and 19mm, or adjustable
open end wrench
• Hex wrenches: 4mm, 5mm, 6mm
• Cross-tip screwdriver
• Razor blade knife
2.2.
Unpacking
Unpacking and installation of the treadmill should be done by a
qualified technician. The packaged treadmills are very heavy
and weigh as follows:
• L7 models: 360 lb, packaged
• L8 models: 435 lb, packaged
Note:
Move the shipping pallet to location where treadmill will be
used before unpacking.
Note:
For L7 treadmills begin with step 1. For L8 treadmills begin
with step 5.
1. For L7 treadmills, the 1/2 inch bolts (total 4) that hold the
treadmill to the pallet must be removed.
2. Remove the two top center bolts (Figure 2-1).
WARNING
To avoid injury, use caution when moving
and lifting the treadmill during unpacking
and assembly.
