Assembly
Installation
19
21. Locate the Wire Tie coming from the Upright Cable Routing Hole
as shown in the following figure. Wrap the wire tie around the
Upper Wire Harness and feed the connector into the upright and
pull the Upper Wire Harness through the Upright and out of the
Upper Access Hole (Figure 2-22). Connect ground wire and main
harness to lower control board and frame.
Figure 2-22. Upper Wire Harness Routing Path
22. Connect the Ribbon Cable and the Pulse Cable from the Remote
Console to the corresponding cables from the Console/Display
(Figure 2-23).
23. Ensure cables are not crimped or caught between Console/Display
and Upright and engage the studs on the Console/Display in their
keyways and slide toward you to lock the Console/Display in place
(Figure 2-23).
Upright Cable
Routing Hole
Guide Wire Tie
