Assembly Instructions
• Connect the harness from the
inside of the POD to the back of
the upper board.
STEP 12:
Connect the harness
• Feed upper harness down
the upright leg making sure to
attach using the blue harness
clips.
•
NOTE:
Leave slack in the
harness to not stress/pull it
when control panel is pressed
into position.
• Feed harness through access
hole at the bottom.
STEP 13:
Route the wire harness
• Align the control panel into
operational position but DO NOT
PRESS ALL THE WAY IN.
• Proceed with assembly until you
can verify that connections are
correct - THEN PRESS INTO
POSITION.
STEP 14:
Position the control panel
• Carefully align the upright cover to
upright leg. Align one edge and
slide all the way up and under
the POD concealing the top edge.
• Once the cover is in position,
press the other edge until the
cover snaps in.
STEP 16:
Install upright covers
• Check the tension on the
drive belt by placing the drive
belt between your thumb and
forefinger and twisting.
• The proper twist is 45˚. If the
belt needs to be adjusted use
a 7/16” socket and turn the
nut underneath the motor pan
attached to the motor tension
screw.
STEP 17:
Check drive belt tension
• The treadbelt is tracked and
tensioned via the take-up
screws located at the back of
the treadmill.
• Check the tension of the
treadbelt. At proper tension
you should be able to place
your hand between the belt
and deck and reach the center
of the treadmill. If you cannot
reach the center, the belt is too
tight and must be loosened.
If your hand reaches past the
center the belt is too loose and
must be tightened.
STEP 18:
Adjust the treadbelt
• The black Phillips head motor
cover screws and spacers
were installed prior to shipping;
remove them.
• Position motor cover in place
and put the rubber spacer
between cover and frame.
Using motor cover screws, install
cover into place.
• Plug treadmill into a dedicated
15 amp outlet. Start treadmill
and walk at 2.5 mph for 20 to
45 minutes to properly “walk in”
lubrication.
STEP 19:
Install motor cover
HOME/LTD TREADMILL:
• Route wire harness
underneath
the elevation motor. Secure with
harness restraint clip provided.
Plug connector into lower circuit
board until it snaps.
CONNECT
INSULATED GROUND LEAD
FROM HARNESS TO AVAILABLE
PAN GROUND LEAD.
CLUB TREADMILL:
• Route wire harness
behind
the
elevation motor. Secure with
harness restraint clip provided.
Plug connector into circuit board until
it snaps.
CONNECT INSULATED
GROUND LEAD FROM HARNESS TO
AVAILABLE PAN GROUND LEAD.
STEP 15
Motor pan connection
3
