2
MOUNT PROXIMITY SWITCH
This manual covers the installation of the Rev II Speed sensor bracket for Harley Cush Drive
Models. Start by removing the existing bracket, and peeling the sensor off the old mount. You
may wish to cut the wire ties that hold the sensor wire so you have more leeway for the new
bracket.
This step is crucial!!
Understand it before starting. The proximity sensor tells the system
how fast the bike is traveling. The proximity sensor mounts to the swing-arm at the rear rotor.
You need to jack up the rear wheel so we can spin it to test the sensor and its placement. Make
sure the bike is in neutral.
Remove the bottom bolt from the
right shock at the rear of the bike.
Insert the top of the bracket
shown at left, behind the shock
and in front of the hole in the
swing-arm, so the bolt will pass
though it when reinserted.
NOTE: the yellow sensor seen
here will be close to the brake
rotor and below the shock bolt
(see below).
Reinsert the shock bolt and
tighten the nut, while holding
the bracket forward against
the swingarm as seen here.
Get the shock bolt snug!
We next have to set the
sensor so it finds the spokes
of the brake rotor (not the
bolts as in the past!) at a
distance of 5MM (about ¼”).
Be prepared to bend the
bracket to get to the sensor in
the correct position.