![background image](http://html2.mh-extra.com/html/landini/5860/5860_operation-and-maintenance-manual_3500580107.webp)
103
Gearbox with 36 forward speeds
Available on request in certain markets
Gearbox with creeper and underdrive
On request, the tractor can be equipped with a gearbox
with creeper with 1:5, 12 reduction ratio and underdrive
with 1: 1.2 reduction ratio able to obtain a total of 36
forward speeds and 12 reverse speeds as follows:
12 forward creeper speeds from 0.3 Km/h to
5.6 Km/h.
12 forward speeds reduced by 20% from 1.4
km/h to 25.0 Km/h.
12 standard forward speeds from 1.7 Km/h to
29.5 Km/h.
12 standard reverse speeds from 0.9 Km/h to
13.4 Km/h.
The gearshift levers (C) (Fig. 83) and those to select the
low, standard and high ranges (A) are the same as
those of the standard gearbox, while lever (B) is used to
engage the creeper and underdrive.
To engage the underdrive or creeper, disengage the
clutch, stop the tractor (only for the creeper) and move
the control lever (B) to the desired position: the
underdrive and direct drive are synchro meshed while
the creeper is engaged by means of a sliding speed.
The table on page 104 gives the speeds in Km/h with
the engine at top rate and with rear tyres as shown.
Gearbox with 36 forward speeds
Gearbox with creeper and overdrive
On request in some markets where permitted by the
Highway Code, the tractor can be equipped with a
gearbox with overdrive able to obtain a maximum
speed of approx. 40 Km/h and which, when combined
with the creeper with 1:5.12 reduction ratio, obtains a
total of 36 forward speeds and 12 reverse speeds as
follows
Only available on request in certain export markets.
12 forward creeper speeds from 0.3 Km/h to
5.6 Km/h.
12 standard forward speeds from 1.7 Km/h to
29.5 Km/h.
12 standard forward speeds with overdrive
from 2.2 Km/h to 37.8 Km/h.
12 standard reverse speeds from 0.9 Km/h to
17.7 Km/h.
The gearshift levers (C) (Fig. 83) and those to select the
low, standard and high ranges (A) are the same as
those of the standard gearbox, while lever (B) is used to
engage the creeper and overdrive.
To engage the overdrive or creeper, disengage the
clutch, stop the tractor (only for the creeper) and move
the control lever (B) to the desired position: the
overdrive and direct drive are synchro meshed while the
creeper is engaged by means of a sliding sleeve.
The table on page 105 gives the speeds in Km/h with
the engine at top rate and with rear tyres as indicated.
NOTE:
When the tractor is equipped with a creeper,
this latter should not be used when the range selection
lever (A) is in the high range position. It can be used in
high range for work with the PTO but must not be used
in high range for draft work (ploughing, sub-soiling,
etc.).
Fig. 83