Operator Manual - GRIND PRO DUAL
Landis International - 11
ACCESSORIES
ACCESSORIES ON QUICK CHANGE BAYONET FITTING
Both ends of the sanding shaft are machined
to accommodate bayonet fitting (quick
change). Extra tools and sanding wheels are
available on request. (see accessories page
25-26)
When removing the quick change fittings, use
the special black
spanner wrench
(SKU: CCL)
supplied with the machine.
Check that the
main switch is off
. To remove, engage the
spanner in the hole near the end of the
bayonet fitting and apply a sharp rap
downward.
Before putting on a fitting be sure the opening
ends are cleaned. Hand tightening is
sufficient to hold the fitting in proper position.
N.B. When properly mounted, the bayonet fitting will
tighten itself by rotating it in the socket in the opposite
direction of the sanding belt rotation.
•
FAILURE TO PROPERLY MOUNT THE ADAPTOR WILL RESULT IN FLYING APART AND POSSIBLE INJURY TO THE
OPERATOR AND OTHERS IN THE WORK AREA.
•
THESE QUICK CHANGE ACCESSORIES SHOULD BE PROPERLY ENGAGED ON THE SHAFT TO ENSURE SAFE
OPERATION. MAKE SURE PIN ON SHAFT ENGAGES THE ADAPTOR CORRECTLY.
To remove the quick change fitting. Help you
and hold the other bayonet with your hand.
To fix the quick change fitting.
