Landmann Vinson VS32, Assembly And Operation Manual

8

Vinson VS32

Assembly

Here are a few tips to help you assemble your barbe-

cue quickly and successfully:

• 

Check that no parts are missing by placing all of 

the individual parts on an empty table (subject to 

minor technical changes).

• 

If,  despite  careful  factory  checks,  a  component 

should  be  missing,  please  contact  our  customer 

service department (see last page). We will imme-

diately attend to your request.

• 

To assemble the barbecue you only need a medi-

um-size screwdriver as well as 10 mm open ended 

spanners.

• 

Only use tools that are intact and suitable for the 

job  at  hand.  Worn  or  unsuitable  tools  will  not 

allow you to tighten the bolts sufficiently, but will 

damage them to the extent that they can no lon-

ger be turned.

• 

Always  fit  all  connecting  elements  (screws,  nuts, 

bolts, et cetera) as shown in the illustrations. If you 

misplace a connecting element, replace it with an 

appropriate part. Only by doing this can you ensu-

re that the construction is strong and safe.

• 

Be sure to follow the instructions in the specified 

order!

• 

Even if you are not experienced at DIY, assembly 

does not generally take longer than one hour.

• 

 The illustrations showing the assembly steps are 

at the end of this manual.

Permitted gas cylinder sizes

4.5 kg:

   Ø 240mm x 340mm

7 kg:

Ø 256mm x 495mm

Connecting and disconnecting 

the gas cylinder

Parts and tools needed 

•  Gas cylinder

Common camping gas cylinder, fill weight 4.5 or 

7 kg, (e.g. grey camping propane gas cylinder). 

These are available at DIY shops or from liquid gas 

suppliers.
Leak indicator

•  You can locate any leaks in the gas system using a 

leak detector. This can be purchased at DIY shops 

or liquid gas suppliers. Please follow the operating 

instructions of the leak detector.

The following parts are included in delivery. They 

comply with the standards applicable in the country 

to which they have been supplied by LANDMANN.
Gas hose (pre-assembled)

-approved hose of a sufficient length (max. 1.5 m) 

to allow for kink-free assembly.

•  Pressure regulator (already attached to the gas 

hose)
Preset and  -approved pressure regulator, max. 

1.5 kg/h, operating pressure 28-30/37 mbar, suita-

ble for the gas cylinder used.

It is recommended that you only use propane gas 

with your LANDMANN barbecue which is fitted with 

a propane gas regulator!