8
INSTALLING YOUR DOOR HANDLE AND SHELVES
INSTALLING THE DOOR HANDLE
1. Open the door and carefully pull the door gasket around the area where the handle is to be installed. It is best to start at one of the corners of
the door gasket and work your way towards the screw positioning.
2. Insert each Phillips head screw through the gasket side of the door until the screw passes through the door.
3. Align the handle with the screws and tighten using a Phillips head screwdriver until the handle is flush against the door frame.
Caution: Do not over-tighten the screws as this may cause damage to the handle or to the stainless steel door.
4. Carefully press the door gasket into its original position.
INSTALLING THE SHELVES
1. Open the door completely. The door must be able to open at least 90 degrees for the shelves to properly clear the door gasket.
2. Identify the slots corresponding to your desired shelf height. Ensure that all four (4) track slots - left and right, front and back - are the same
height so that your installed shelf will be level.
3. Lift the front of the shelf [closest to you] at a 20 degree angle above the back of the shelf. Insert the rear pegs on both sides of the shelf into the
rear vertical track mounting slots as shown in step "
A
" below.
4. Push the rear pegs in. Then, set the front shelf pegs into the front vertical track mounting slots as shown in step "
B
" below.
VERTICALLY ADJUSTABLE SHELF TRACKS
This series of Landmark refrigerators is equipped with vertically adjustable shelf tracks. Each user's wine and beverage storage needs are unique
and change over time as your collection evolves. The shelves included with your refrigerator can be installed at the varying heights of the vertical
shelf tracks.
A
B
