3-15.7
Free-wheel the winch cable from winch
#4
(See Figure 3-6)
out until it is at the rear
of the upper deck so it is accessible after
loading the next vehicle.
3-15.8
Connect winch #3
(See Figure 3-6)
to
the next vehicle and pull it to the center posi-
tion on the upper deck. Secure with chains
(See Section 3-17)
.
3-15.9
Connect winch #4
(See Figure 3-6)
to
the next vehicle and pull it to the rear posi-
tion on the upper deck
(See Figure 3-10).
Secure with chains
(See Section 3-17)
.
3-15.10
Unlock and raise the rear arm to an
adequate height to allow clearance for load-
ing vehicles on the lower deck.
3-15.11
Unlock and raise the middle arm to an
adequate height to allow clearance for load-
ing vehicles on the lower deck.
3-15.12
Ensure that all arms are locked in po-
sition
(See Section 3-12).
3-16 LOADING THE LOWER DECK
3-16.1
Make sure there is adequate
clearance between the upper and lower deck
to load vehicles on the lower deck
(See Fig-
ure 3-11).
3-16.2
If the approach plate is not already on
the ground, pull the trailer axles forward,
then tilt the trailer with the
TRAILER TILT
CONTROL
until the approach plate of the
lower deck touches the ground
.
3-15
Figure 3-10 Loading the Upper Deck
Summary of Contents for 336C
