2-6
F-581-R1
PLANNED MAINTENANCE
Figure 2-7: Engine Compartment Fluid Checks
Check Engine Oil Level
1.
Lower the mast to within a few inches of the ground,
then tilt it back completely.
2.
Open the engine compartment by releasing the latch
just under the driver in the front of the compartment.
See Figure 2-5.
3.
Remove engine oil dipstick and wipe end with a clean
rag.
4.
Insert dipstick and remove observing the oil level.
5.
Ensure the oil level is at the proper level as indicated
by the marks on the dipstick.
6.
Clean the area around the engine fill cap, then open
the cap (turn counterclockwise). See Figure 2-7.
IMPORTANT
• It is important that the proper level of oil be
maintained at all times. Failure to check the oil
level as recommended could cause serious
malfunction problems.
7.
Add engine oil as needed.
See page 1-17
for
recommended lubricants.
8.
DO NOT OVERFILL. With the level above the FULL
line, the oil does not have enough area for expansion
when it heats up during normal operation.
9.
If the fluid appears dirty or dark in color, check the
forklift’s maintenance log for the last fluid and filter
change and then change accordingly.
10. Install the fill cap, making sure it is tight.
11. Close and latch the access assembly and doors.
Summary of Contents for Bendi B40i4
