4-10
F-808-R0
OPERATING THE B40I4 FORKLIFT
2.
For narrow aisles, straighten out the truck so it is 8 in.
from the edge of the aisle opposite the load Item 2 -
See Figure 4-11. For wider aisles, straighten out the
truck so it is 36 in. to 48 in. from the side of the aisle
where the load is located. Item 6 - See Figure 4-11.
3.
Center the forks using the side shift lever.
DANGER
4.
Drive forward until the front edge of the load wheels
are aligned with the center of the pallet. Items 3 and
4 - See Figures 4-11 and 4-12.
5.
Lift the forks to the required height, and then level the
forks using the tilt lever.
6.
Stop the forklift and turn the forks 90° using the
steering wheel to align them with the load. See
Figure 4-13.
Figure 4-11: Setup - Load Pick Up
Figure 4-12: Align the Forks
7.
Straighten out the forks using the steering wheel as
you drive them into the load so the forks enter the
load in a straight line. See Figure 4-14.
Figure 4-13: Positioning the Forks
If the forks or load jam or catch during a stacking
operation, do not attempt to free them by
reaching through the mast.
Failure to follow this instruction can cause
serious injury or death.
1
4
5
6
2
3
S
S
S
Summary of Contents for Bendi B40i4
