OPERATING THE B40I4 FORKLIFT
4-11
8.
Turn the steering wheel to keep the forks straight as
you fully insert them into the load. Lift, tilt, and side
shift as required to stabilize and pickup the load. See
Figure 4-15. Only raise the load high enough to clear
the rack or the load backrest may catch on the rack.
NOTE
With extreme care and experience, all movement may be
controlled to a greater extent by the use of an inching
procedure.
9.
Shift into reverse and slowly back away from the
stack as you turn the steering wheel to keep the forks
straight. See Figure 4-16.
10. You may need to side shift as you back out the load
to clear the rack.
11. If you still are unable to get enough clearance, drive
forward and try the removal process again. To get
more clearance, don’t start turning the forks until you
have backed out 8 in. to 16 in.
Figure 4-14: Inserting the Forks into the Load
Figure 4-15: Retrieving the Pallet
12. When the front right hand corner of the load clears
the rack, stop backing and turn the steering wheel
clockwise to straighten out the forks, so they are
parallel with the body of the truck. See Figures 4-16
and 4-17.
13. Lower the forks until they are 4 in. to 6 in. off the
ground and slowly drive the truck to the next location
observing the safety rules previously stated.
WARNING
S
Lowering the mast improves driver visibility, and
improves the stability of the truck by reducing the
possibility of personal injury or damage to the
load if it were to slip from the forks.
S
Summary of Contents for Bendi B40i4
