4-12
F-808-R0
OPERATING THE B40I4 FORKLIFT
Figure 4-16: Retrieving the Load
Figure 4-17: Normal Travel Position
Transporting a Load
Follow these guidelines when you transport a load:
• Do not speed.
• Use your horn to warn others of danger.
• Make sure the load is seated firmly against the fork
backrest.
• Tilt the mast back.
• Lower the load to recommended traveling position
before moving the load to another location.
• Be alert to overhead obstructions such as low
doorways, racking and pipes. Make sure you know
the raised and lowered heights of the mast.
• Make sure the load is not wider than the width of the
gangways or aisles, especially if you are backing a
bulky load down an incline.
Traveling on Inclines
DANGER
When you travel up or down an incline, follow these
guidelines:
• Make sure the gradient is 5% or less with a loaded
Bendi B40i4 forklift and 8% or less if you are not
carrying a load.
• Always keep the load pointed uphill. See
Figure 4-18. Travel with the forks facing uphill
whether you are going up or down an incline. You
must then back down an incline when you are
carrying a load. If vision is obscured, arrange for a
‘Banksman’ to guide you.
• If you are not carrying a load, travel with the forks
facing uphill when you are going up the incline and
face the forks downhill when you are traveling down
an incline. See Figure 4-19.
• Raise the forks as necessary to avoid damaging the
forks or load as the road surface changes grade at
the top or bottom of an incline. Lower the forks to 4
in. to 6 in. off the ground when you clear the incline.
S
1
S
Use extra caution when operating on ramps.
Never travel across a grade.
Travel slowly and do not turn.
Travel with load uphill.
Travel with empty forks downhill.
Failure to follow these guidelines can cause
serious injury or death.
Summary of Contents for Bendi B40i4
