OPERATING THE B40I4 FORKLIFT
4-13
Figure 4-18: Traveling Uphill
Figure 4-19: Traveling Down an Incline
Unloading the Forklift
NOTES
Actual minimum aisle width may vary based upon
application. Item 5 - See Figure 4-20.
The following illustrations show standard 40 in. x 48 in.
(W x L) pallets loaded on a rack with 96in. beams. The
arrow labeled with an ‘S’ shows the direction you must
turn the steering wheel.
Follow these steps to store a load:
1.
Approach the side of the aisle that is opposite the
area where you will unload the forklift. Item 1 - See
Figure 4-20. For narrow aisles, straighten out the
truck so it is 6 in. to 8 in. from the edge of the aisle
opposite the drop off point. Item 2 - See Figure 4-20.
2.
For wide aisles, straighten out the truck so it is 36 in.
to 48 in. from the side of the aisle where the load is
located. Item 6 - See Figure 4-20.
3.
Center the load using the side shift lever.
4.
See Figure 4-20. Drive forward until the front edge of
the load wheels, items 3 and 4, are aligned with the
center of the rack opening.
DANGER
5.
Lift the load to the proper height.
6.
Stop the forklift and turn the load 90° (turn the
steering wheel counterclockwise) so it points in the
direction you will drop it off. See Figure 4-21.
Figure 4-20: Setup - Delivering a Load
If the forks or load jam or catch during a stacking
operation, do not attempt to free them by
reaching through the mast.
Failure to follow this guideline can cause serious
injury or death.
1
4
5
6
2
3
S
Summary of Contents for Bendi B40i4
