4-14
F-808-R0
OPERATING THE B40I4 FORKLIFT
Figure 4-21: Load Drop-Off
7.
Drive forward and straighten out the load using the
steering wheel so it is square over the stack. See
Figure 4-22.
Figure 4-22: Straighten the Load for Drop-Off
8.
Turn the steering wheel to keep the load straight as
you drive it into the opening. See Figure 4-23.
Figure 4-23: Inserting the Load
9.
Position the load directly over the rack beams and tilt
the mast into its vertical position.
DANGER
10. Lower the forks until the load sits firmly on the rack.
Continue to lower the forks until they no longer
support the load (‘no load’ position). See Figure 4-24.
DANGER
NOTE
Do not tilt the mast back until the forks clear the pallet.
S
1
S
When you lower the forks to the “no load”
position, make sure you do not lower the forks
too far. See Figure 4-24. If the forks are lowered
too far beyond the “no load” position, you can
damage the mast, rack, or other containers on the
stack. This can cause serious injury or death.
Do not attempt to withdraw the forks until they
have been lowered to a “no load” position.
Failure to follow this guideline can cause the load
to fall off the stack causing serious injury or
death.
S
Summary of Contents for Bendi B40i4
