5-7
Unusual Noises
The operator, as well as the maintenance technician,
should be aware and take action on any unusual noises
that may surfaced.
The type of noise, such a grinding or a growl, as well as
the location of the noise can determine if or what type of
maintenance needs to be taken.
Most grinding noises may indicate a need for mast rail
lubrication or a faulty wheel bearing.
Growling noises can indicate faulty hydraulic pumps or
simply low oil in the hydraulic tank.
Any unusual noises should be noted in the daily check
sheet and reported to the person in charge of repairs and
maintenance immediately.
General Truck Lubrication
Inspect lubrication points. See Figures 5-4 and 5-5.
These lubrication points along with proper recommended
lubricants ... See Table 5-1 on page 5-7 ... are designed
to extend the service life of the truck and prevent major
problems, causing costly downtime.
Figure 5-4: Rotation Bearing Grease Points
Recommended Lubricants
See Table 5-1 below for recommended lubricants.For
specific areas to lubricate the forklift - See Figure 5-5.
Table 5-1: Lubrication Chart
Name
Lubrication
Comments
1. Chain
SAE40W oil or Bowman Heavy Load Red Grease
Clean and reoil
2. Upright Rail
Chassis Lube or Kendall SR-12X
Lubricate inner sides of upright rails
3. Rotation Bearings
Texaco Ref. C & C #880
Use standard lubrication gun
4. Steering Knob
Light weight oil
Lightly oil
5. Engine
SAE 10W30 API “SL”
Drain, flush and refill
6. Hydraulic Reservoir
Conoco Power flow HE (ISO Grade 46) Filtered to
ISO 4406 cleanliness code 15/13/11 or equivalent
Grade oil filtered to 15/13/11.
Drain, flush and refill
7. Tilt Cylinders
Texaco Ref. C & C #880
Use standard lubrication gun
8. Articulating Axle
Bearings
Texaco Ref. C & C #880
Use standard lubrication gun
9. Load Wheel Axle
Texaco Ref. C & C #880
Use lubrication gun and adapter for
flush type fittings
*Failure to refill with oil that meets ISO 4406 cleanliness code 15/13/11 may void the warranty. Typical
“NEW” oil DOES NOT meet this specification. Contact Landoll Corporation or your lubricant supplier for
recommendation.
Summary of Contents for Bendi B40i4
