2-14
1P124-2306
Latch Installation
Large Seed Box Cover with Latches and Gas Springs
1. Place the Gasket on Latch Base and place on Seed
Box Cover.
2. Install Slotted Screws to secure Latch to Cover.
3. Thread the nut onto Latch Rod, then slide on Internal
Tooth Washer, Pawl, the other Internal Tooth Washer
and then thread on the other nut. Hand tighten only.
Close the Cover and turn Latch to see if Pawl fits snug up
against Seed Box Lip. If it does not, open Cover and
adjust nuts accordingly. When properly adjusted,
securely tighten latch nuts.
Cover Gas Spring Installation
NOTE
Gas Spring rod end must be down for proper
functionality.
1. Snap Gas Spring rod end onto Seed Box Gas Spring
Bracket.
2. Swing Gas Spring base end up to Cover Ball Stud and
snap in place.
Figure 2-20: Latch Installation
Latch
Gasket
(2) Slotted
Screws
Pawl
(2) Nut
(2) Internal
Tooth
Washers
Pawl
(Closed Position)
Gas Spring
Gas Spring
Rod end must
be down
Gas Spring
Mounting Bracket
Ball Stud
Locknut,5/16-18
Gas Spring
Cover
Latch
Latch Pawl
Slotted Screws
Bolt,1/4-20
x 1/2
Summary of Contents for Brillion Turfmaker III Series
