025-FIS18_Smart_GATEWAY
10
9
10
3.2b
ASSOCIATING THE DEVICE WITH THE RECEIVER
After the procedure in paragraph 3.2a is complete, the various devices which have been created will be displayed on the
homepage of the application.
The next step is to associate each device with the receiver to be driven.
The receiver must be accessed to complete this step.
PROCEDURE
3.3
DELETING OR MODIFYING A CREATED DEVICE
If you wish to delete or modify a created device, change the name, icon or the type of command, perform the following
procedure:
STEP2
Click on "menu".
STEP1
Access the application according
to the network configuration
performed in paragraph 2
STEP6
A list of created devices will
appear.
Select the device to be modified
STEP5
Premere su “lista dispositivi”
menu
Devices
Configure system
LIST OF DEVICES
LIST OF GROUPS
RESET
STEP3
Click on "Configure system"
Configure system
Devices
Settings
Configure network
Configure system
STEP4*
You will be requested to enter a
password; the default
password is: “1234”.
Confirm
Cancel
Password
Enter password
1234
list of devices
List of devices
STEP7
Click on "edit” to change the
settings or "delete" to remove it
Device 1
List of devices
Device 1
Edit
Delete
ATTENTION
In step 4 of the procedure, the default values to be used will be suggested.
If these were modified previously and cannot be recovered, the system must
be reset; see paragraph 7.1.
A reset will not delete systems created in the interface (see paragraph 3);
it will only reset the network settings (network name, page address,
password).
The default password from "step 4" can be changed by accessing
"menu-settings-change password"
STEP2
While programming the radio, you will be requested to transmit a command. To transmit the command, select the
device on the homepage and transmit any command using the keys available.
The receiver flashes three times to confirm programming was successful.
STEP1
Access the receiver and perform the radio programming procedure for the multifunction radio transmitters.
See receiver manual.
Make a short
press of
the button
Make a short press
of the button related to
the output which the
transmitter wants
to be programmed.
THE LED TURNS ON
SMART1
SMART1
SMART4
SMART4
THE LED TURNS ON
LED MAKES 3 FLASHES
AND TURNS OFF
LED MAKES 3 FLASHES
AND TURNS OFF
SELECT THE DEVICE ON THE HOMEPAGE AND TRANSMIT
ANY COMMAND USING THE KEYS AVAILABLE
