025-FIS18_Smart_GATEWAY
9
7
8
NOTE
In step 4 of the procedure, the default values to be used will be suggested. If these were modified previously and
cannot be recovered, the system must be reset; see paragraph 7.1.
A reset will not delete systems created in the interface (see paragraph 3); it will only reset the network settings
(network name, page address, password).
The default password from "step 4" can be changed by accessing "menu-settings-change password".
3.1
INTRODUCTION
After the procedure in paragraph 2 is complete, the personal device is able to communicate with the hub.
The following step creates the various user command interfaces which will appear on the home screen of the application.
These interfaces can be either devices or groups.
Devices: the term device refers to an interface which is used to drive a load (e.g.: light or roller shutters)
Groups: the term ‘groups’ refers to an interface which is used to drive a set of previously created devices. This is useful for
creating a "switch OFF all lights" command or "lower all roller shutters" command.
To create devices, see paragraphs 3.2 and 3.3; to create groups, see paragraphs 3.3 and 3.4.
NOTE: both devices and groups will appear on the homepage. It is recommended to use the name which is assigned to
each interface to distinguish group commands from commands for a single device
3.2a
CREATING A DEVICE
3 - SYSTEM CONFIGURATION
STEP2
Click on "menu".
STEP1
Access the application according
to the network configuration
performed in paragraph 2
STEP6
A list of created devices will
appear (the default list has no
devices).
Click on the "+" button to add
devices
STEP5
Click on "list of devices"
menu
Devices
Configure system
LIST OF DEVICES
LIST OF GROUPS
RESET
STEP3
Click on "Configure system"
Configure system
Devices
Settings
Configure network
Configure system
STEP4*
You will be requested to enter a
password; the default
password is: “1234”.
Confirm
Cancel
Password
Enter password
Saving device
Deviced saved
1234
list of devices
+
List of Devices
STEP8
Click on "save" at the bottom of
the page.
STEP9
The application displays the list
of updated devices. If you wish
to add more devices,
return to step 2 of this procedu-
re.
If all user command interfaces
have been created, go to step
3.2b to associate them with the
central receivers.
STEP7
The fields to fill in to create the device will appear:
NAME: the name which will appear on the homepage
TYPE OF COMMAND: determines the user command interface and, therefore, the actions which can be perfor-
med. This field is chosen according to the receiver to be controlled. See the table below
ICON: the graphic icon which appears to the side of the device; for graphic purposes only
Configure system
Save
Name
Type of
command
Icon
TYPE OF COMMAND
On-Off
Open-Stop-Close
Impulse
Dimmer light
RGB/RGBW light
Tunable white light
EXECUTABLE ACTIONS
On - Off
Open - Stop - Close
Impulse
On - Off - Intensity setting
On - Off - Intensity setting - Colour management
On - Off - Intensity setting - Tunable light management
