Landworks GUO023, Instruction Manual

Overload Protection

This Chipper/Shredder is equipped with an overload protection system. If the unit clogs while 

running, the overload protection system will shut the power off. Wait at least one minute before 

restarting. Press the Reset Button then turn the Power Switch on.

Maintenance and Servicing

Procedures not specifically explained in this manual must be performed only by a qualified 

technician.

WARNING!

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION OR ELECTRIC 

SHOCK:

Turn the Power Switch of the appliance to its “OFF” position and unplug the 

appliance from its electrical outlet before performing any inspection, mainte-

nance, or cleaning procedures.

TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:

Do not use damaged equipment. If abnormal noise or vibration occurs, have the 

problem corrected before further use.

Cleaning, Maintenance

1. BEFORE EACH USE, inspect the general condition of the tool. Check for:

• loose hardware,

• misalignment or binding of moving parts,

• cracked or broken parts,

• damaged cord/electrical wiring, and

• any other condition that may affect its safe operation.

2. AFTER USE, clean external surfaces of the appliance with clean, moist cloth.

3. Replace or sharpen the Blades as needed. (See below.)

4. If the motor turns but the appliance does not function, the belt may be broken. Have the belt 

replaced by a qualified technician.

5. 

WARNING! If the supply cord of this appliance is damaged, it must be replaced only 

by a qualified service technician.

Cleaning the Chipper/Shredder

1. Turn the Hopper Locking Knob counterclockwise and remove the Hopper.

2. Clean the cutting Blades and discharge area and remove wood sticks or objects that may 

clog the Blades.

3. Check the Blades for damage and replace if needed.

4. Return the Hopper to its upright position and tighten in place with the Locking Knob after 

cleaning the interior.

5. Use a warm damp cloth and a soft brush to 

clean the exterior of the Chipper/Shredder. 

Do not spray water or use detergents on 

the Chipper/Shredder.

6. Check that the ventilation slots are clean.

Replacing the Blades

The reversible Blades are attached to the

Cutter Head with two screws.

E6

Figure E

Blades

Screws