Page 5
REAR VIEW
The Power inlet and switch. This switch will turn on and off the pedal. We suggest turning the pedal
off when plugging in the power supply. IRONHEART logo will light up on the front indicating the
pedal is on. The LOUDPEDAL has an included power supply runs universally at 100-240V~.
Warning: Only connect the provided 24V 2.5A power supply to the DC inlet.
3.5mm jack to connect your headphones for silent practice. Your selected tone will play directly into
your headphones. Adjust the level using the channel volumes controls. Can also be connected to a
speaker simultaneously, producing sound at both outputs.
3.5mm jack to plug in any audio playing device to add a backing mix to your guitar track. This is
added after the FX loop.
A balanced XLR output to your external device such as a PA or audio interface. Set your desired tone
on the pedal first then set the parameters on your chosen interface to get the sound you want.
•
SPEAKER EMULATION - Use to turn on and off the inbuilt speaker emulation for your DI output.
A high-quality emulation that will give you the authentic loudspeaker sound direct to your audio
interface.
•
GROUND LINK - Disconnects the ground from pin 1 of the DI output ONLY. Useful to attempt to
reduce ground loop hum when connected.
