UL File# E8138 Rev New
9
INSTALLATION CONT’D
Reversing the door
1.
Disconnect oven from power.
2.
Remove the top and bottom door hinge covers (4) by removing the two 10-32 phillips
head screws (8).
3.
Remove the top door hinge bracket (1) from the oven by removing the two 1/4-20
phillips head screws (7). The hinge should slide off of the door pin. This will now be
your right hand lower hinge.
4.
Lift the door off of the bottom pin and set it aside.
5.
Remove the bottom door hinge bracket (2) by removing the two 1/4-20 phillips head
screws (7). This will now be your upper right hand hinge.
6.
Remove the lower hinge mounting plate (9) by pulling it from behind the leg pad
adapter on the bottom of the oven.
7.
Remove the two phillips head screws in the bottom right corner of the oven where the
new hinge will be placed.
8.
Slide the hinge mounting plate (9) into place and mount the hinge bracket (this should
be your old upper hinge) using two 1/4-20 (7) phillips head screws.
9.
Remove the two phillips head screws in the upper right corner of the oven where the
new hinge will be placed.
10.
Rotate the door 180
°
and slide the door pin into the bottom hinge bracket.
11.
Slide the upper door hinge (1) onto the upper door pin and screw into place using two
1/4-20 phillips head screws.
12.
Place the top and bottom door hinge covers (4) back on the oven using two 10-32
phillips head screws (8).
