UL# MH19366
Rev. A2003
16
NCC GRILL CONTROLLER (Cont’d)
CLEANING
As needed, wipe the surface of the controller with a damp towel to remove any
dust, grease, or debris.
OPERATING CONDITIONS
•
Grill controller operating in the auto scan mode.
•
Each section is set for the correct temperature.
•
Indicator lights are green when corresponding lane temperature is reached.
•
Indicator lights are yellow when the corresponding burner is on.
•
No lights are blinking.
•
The display shows Lane # (x) (xxx) F.
ADJUSTING TO
SPECIFICATIONS
Changing to Calibration Mode
When the controller is in the calibration mode, the temperature the controller reads
from the probes can be changed to match the grill surface temperature measured by
a thermometer.
Checking Set Temperatures
1. Press SEL until LUNCH SET #1 (xxx) F displays.
2. Press UP ARROW to move to the next lane.
Changing Set Temperatures
1. Press PROG/UP ARROW at the same time.
2. Press SEL to scroll to “Temperature Setting.”
3. Press ENT to select this menu.
4. Press SEL 2 times to scroll to “LUNCH SET” (xxx) F.
5. Press UP or DOWN ARROW to change temperature setting.
6. When temperature is set, press ENT to move to the next lane.
7. When all temperatures have been set, press PROG and ENT at the same time
to exit programming.
NOTE: Controller will automatically go back to the auto scan mode.
Checking the Grill Controller Settings
The controller must be set to the correct grill type, number of burners, and the grill
configuration (standard or reverse).
1. Press PROG and UP ARROW at the same time.
2. Press and hold PROG for 5 seconds.
3. Press SEL to scroll through menu options.
4. GRILL TYPE (xxxxxxx) –Press UP ARROW to choose between WOLF &
LANG or US RANGE grills and press SEL.
5. # of BURNERS (x) – Select the number of burners installed in the grill (x) =
2,3,4,5,6,7, or 8. Press UP ARROW to increase the number; press DOWN
ARROW to decrease the number. Press SEL.
6. GRILL CONFIGURATION (xxxxxxx) – Press UP ARROW to choose
STANDARD or REVERSE grill. Press SEL>
7. BURNER DELAY (10) SEC – The burner delay should always remain at the
default of 10 seconds. Press SEL.
8. Press PROG and ENT at the same time.
Exiting the Programming Mode
Press PROG/ENT at the same time to exit the programming mode. NOTE: No key
pressed for 2 minutes will cause the controller to exit the program mode or grill set-
up menus.
Foodmaker, Inc.
