6
2M-W1091, Commerical & Marine Electric Range T
op
2M-W1091, Commerical & Marine Electric Range T
op
INSTALLATION
Electrical Connection
Make all electrical connections in accordance with local codes or
in the absence of local codes with NFPA No. 70 latest edition (in
Canada use: CSA STD. C22.1).
Place spacers, (i.e. 2x4 wood block not supplied) at the front and
rear of the oven top.
Place the range top on the spacers that are located on top of the
oven.
The six wire leads that supply electricity to the cook top are bundled
under the front of the top. Route the six wires through the bushing
provided in the oven top.
Align the four locating pins in the bottom corner of the top with the
four holes in each corner of the oven top.
Remove the spacers and lower the top onto the oven.
The range can now be connected to power.
Use the wiring diagram provided in this manual for determining the connections of the cook top wires to
the oven terminal block.
MAKE SURE THE SIX WIRE LEADS TO SUPPLY ELECTRICITY TO THE RANGE
TOP ARE NOT CRIMPED BETWEEN THE OVEN AND RANGE TOP. FAILURE
TO COMPLY WILL RESULT IN DAMAGE TO EQUIPMENT.
TURN OFF THE MAIN POWER SUPPLY TO THE RANGE AT THE SOURCE
PRIOR TO CONNECTING POWER TO THE RANGE. FAILURE TO COMPLY MAY
RESULT IN SERIOUS INJURY AND OR DEATH.
THIS APPLIANCE MUST BE GROUNDED AT THE TERMINAL PROVIDED.
FAILURE TO GROUND THE APPLIANCE COULD RESULT IN ELECTROCUTION
AND DEATH.
INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNEL QUALIFIED TO
WORK WITH ELECTRICITY AND PLUMBING. IMPROPER INSTALLATION CAN
CAUSE INJURY TO PERSONNEL AND/OR DAMAGE TO EQUIPMENT. UNIT
MUST BE INSTALLED IN ACCORDANCE WITH ALL APPLICABLE CODES.
The data plate is located right of range top controls. The oven voltage, wattage,
serial number, wire size, and clearance specifications are on the data plate.
This information should be carefully read and understood before proceeding
with the installation.
The installation of any components such as a vent hood, grease extractors,
fire extinguisher systems, must conform to their applicable National, State
and locally recognized installation standards.
BE SURE THE POWER SUPPLY VOLTAGE MATCHES THE VOLTAGE SPECIFIED
ON THE NAMEPLATE LOCATED ON THE FRONT OF THE RANGE. FAILURE
TO COMPLY MAY RESULT IN PERSONAL INJURY AND/OR DAMAGE TO
EQUIPMENT
NOTICE
IL2314
CAUTION
WARNING
WARNING
NOTICE
WARNING
CAUTION