LANIER R/C
EXPLORER 40
ASSEMBLY
INSTRUCTIONS
10
2. Place the straight tube and short bent
tube in the holes in the stopper. The bent
tube will be the vent and must be oriented
toward the top of the tank. Place the large
washer on the front and the small washer
on the backside. Install the screw but do
not tighten. Slip the fuel line on the clunk
pushing the other end on the straight
piece of tubing. Slide the assembly into
the fuel tank pushing the stopper in as far
as it will go. Orient the vent line and the
carburetor line so that they are horizontal.
The nose gear wire must go between
these tubes when the tank is installed.
ASSEMBLING THE NOSE GEAR
1. Locate the hardware bag with the nose
gear parts. The steering tiller arm must
have a wheel collar installed in it. Cut a
slot on the side for the setscrew as shown
in the photo.
When installing the tiller,
the open end should be facing down
.
2. Slide the tiller arm on the nose gear.
Next, slide the mounting block followed by
a wheel collar. Adjust the tiller arm so
that it is ½” above the spring and tighten
the wheel collar. Now tighten the wheel
collar on the topside. Slide on the top-
mounting block. Lay the assembly aside.