LANIER R/C
EXPLORER 40
ASSEMBLY
INSTRUCTIONS
15
2. Drill the hole for the sleeving. Now
drill a hole in the second sub-former, inside
below the fuel tank as shown. This can
done from the front with a long drill or a
hole or slot can be made in the former
reaching through the wing opening.
3. Cut off a piece of white sleeving 12”
long. Cut off a length of .050 wire 14-
1/2” long. Follow the same instructions
as stated in the throttle pushrod hookup.
CA the white sleeving in place.
4. Locate and glue in the sleeving
supports near the servos as shown in the
photo. Loosen the setscrew in the servo
arm connector, power up the servo to
center it, adjust the rudder and nose gear
to neutral. Tighten the setscrew. Final
adjustments can be made in the rudder
by turning the clevis in or out.
MOUNTING THE RECEIVER
SWITCH
1.
Locate the small hole on the left side of
the fuselage in the cabin area. Remove
the covering over it.