9
HINGING RUDDER
1.
Collect the following items
(1) Rudder
(4) Hinges
(1) 6-32 x 3” All Threaded Rod
(2) 6-32 Locking Hex Nuts
(2) #6 Washer
(2) Nylon Adjustable Control Horn
(2) Nylon Adjustable Horn Bracket
1.
Glue the Rudder to the fin the same way you
did the ailerons.
Make sure that the top of the rudder will not rub
on the top of the fin.
2.
Drill a 1/8” hole located at 3/4” back from the
hinge line and 1/2” up from the bottom of the
rudder.
.
Insert the 6-32 x 5-1/2” all threaded rod and
center it using the #6 washer with a 6-32 lock-
ing hex nut.
3.
Place on both ends of the threaded rod a
Nylon Adjustable Control Horn.
Place the spring between the rudder control
horn bracket and the tail wheel tiller arm on
top of the wheel.
INSTALLING MAIN LANDING GEAR
1.
Collect the following items:
(6) 6-32 x 3/4” Socket Head Screw
(1) Main Aluminum Landing Gear
2.
Find the landing gear slot on the side of the
fuselage.
Insert the the landing gear through the slot .
Front
3.
Using the 6-32 bolts and thread lock, mount
the landing gear in the fuselage
