LANIER
– 1.20 Edge 540T ARF -
INSTRUCTIONS
81. Bolt the axle through the landing gear with the
axles pointing out. Use thread lock on the bolt.
82. Install the tip of the axle through the pant, then
the wheel and collar, then slide the assembly all
the way down the axle. Tighten the wheel collar
so that it does not bind the wheel against the
wheel.
83. Align each wheel pant to the fuse so that it is
level with the thrust line and the rear does not
drag the ground, and keep the pair equal. Drill a
small pilot hole in the fiberglass, then install a #4
x ¼” screw through the small hole in the landing
gear.
84. Locate the fuel tank and remove all the
components for assembly. Check the inside of
the tank for any dust or plastic shavings. Blow
out if needed. Notice one side of the tank has an
angle on it. With the fittings to the front, this
side faces up. You may want to mark this side
“top” with a permanent marker.
85. Bend the metal fuel tubes as illustrated on the
included instructions to fit in the tank, then insert
in the fuel stopper. Insert the clunk on the end of
the silicone fuel tubing and cut to required length
that allow it to move freely at the end of the tank.
Insert the nut and bolt in the stopper, then install
the stopper in the tank and tighten.
© 2001 Lanier R/C
Page - 11
