Assembly Instructions
LANIER R/C
MARINER 40 MK II ARF
LANIER R/C, INC.- P O Box 458 - Oakwood, GA 30566 - Ph 770-532-6401
© Copyright 2006 Lanier R/C, Inc.
10
INSTALLING SERVOS AND PUSHRODS
1. The servo rails are pre-installed in the fuse.
2. Install the rudder and elevator servo using
the hardware supplied with the radio. The
servos should be centered with 1-3/4” between
servos.
3. Locate the pushrod material. Cut the outer
sleeving into two equal pieces approximately 22”
long. Cut the inner pushrod into 2 equal pieces
approximately 23” pieces. Screw the short
threaded rods into one end of the pushrod 1/2”.
Install the hex nut and screw on a clevis. Do
two pushrods.
4. Prepare the other end of the pushrods that
will hook up to the servo arms. Locate two
2mm x 6” rods threaded on one ends. Screw
them in 1/2” on both pushrods.
5. Uncover the pushrod exit holes in the aft end
of the fuselage. Enlarge them so the pushrod
sleeving will fit using a motor burring tool or X-
Acto blade. Push the sleeving in leaving approx.
1” extending. Using Silicone Sealer, glue them
in place both sides.
6. Mount both pushrods in the sleeves and hook
up to control horns on rudder and elevator.
Place a hex nut and clevis on each.
