Assembly Instructions
LANIER R/C
MARINER 40 MK II ARF
LANIER R/C, INC.- P O Box 458 - Oakwood, GA 30566 - Ph 770-532-6401
© Copyright 2006 Lanier R/C, Inc.
4
7. You will need two 6” servo lead extension for
this next step. (not supplied), one for each wing.
The extensions must be compatible with your
radio system. Plug the extension into the servo
and secure the connection with tape to make
sure it doesn’t come apart.
8. Locate the string from the servos opening
hole to the end root rib. Tie or tape on the servo
connector and pull it through the wing panel.
Now push it up through the hole in the bottom
of the wing. Tape the end of the lead to the
wing to prevent it from falling back into the exit
hole. Now do the same to the other wing panel.
Align servo as shown.
9. Place the servo board in the wing opening.
Drill four 1/16” holes in each corner through
holes provided. Use the #2 x 3/8” screws
provided. Note: hardware may vary in looks
from that shown.
10. Using a straightedge, place a mark on the
aileron to locate the control horn. The holes in
the horn must be in line with the hinge line.
11. Place the control horn on the mark and CA
it in place using thin CA. Block sanding the base
will help it adhere better. When cured, match
drill the holes with a 3/32” drill. This will give
better screw alignment to the nut plate on the
