Copying
56
2
Note
❒
You can move the scanned posi-
tion up to 30 mm (in 1mm steps)
upward, downward, to left and to
right.
1.
Top: 0 – 30 mm, 0" – 1.2"
2.
Right: 0 – 30 mm, 0" – 1.2"
3.
Bottom: 0 – 30 mm, 0" – 1.2"
4.
Left: 0 – 30 mm, 0" – 1.2"
AAAA
Press the
[
Edit/Stamp
]
key.
BBBB
Press the
[
Edit Image
]
key.
CCCC
Press the
[
Scan Position
]
key.
DDDD
Set the scanned position for the
face of the original. Press the
[
↑↑↑↑
]
or
[
↓↓↓↓
]
key to set the top or bottom
position. Press the
[
←
←
←
←
]
or
[
→
→
→
→
]
key
to set the left or right position.
Note
❒
If you have incorrectly set the
position, readjust with the
[
↑↑↑↑
]
,
[
↓↓↓↓
]
,
[
←
←
←
←
]
or
[
→
→
→
→
]
key.
❒
If you don't need to set the
scanned position of the back of
the original, go to step
F
.
EEEE
Set the scanned position for the
back of the original. Press the
[
↑↑↑↑
]
or
[
↓↓↓↓
]
key to set the top or bottom
position. Press the
[
←
←
←
←
]
or
[
→
→
→
→
]
key
to set the left or right position.
Then press the
[
OK
]
key.
Note
❒
The scanned position for the
back set here is valid when you
copy 2-sided originals.
FFFF
Press the
[
OK
]
key.
GGGG
Press the
[
OK
]
key.
HHHH
Place your originals, and then
press the
{{{{
Start
}}}}
key.
Erase
This func tion erase s the c enter
and/or all four sides of the original
image. This function also erases the
inside or outside of a specified area.
This function has the following three
types:
❖
❖
❖
❖
Border
This mode erases edge margin of
the original image.
1
2
3
4
MartiniC1_GBcopy4_FM.book Page 56 Tuesday, April 23, 2002 6:23 PM
Summary of Contents for LD075
