Copy Settings
42
3
• Auto Energy Saver Mode(+10): The fusing unit needs to be hot for copying.
When the copier is idle, the fusing unit can be kept hot to save time or it can
be allowed to cool to save energy. This feature can be set to start automatical-
ly, but you can also turn it on yourself by pressing and holding the
{
Clear
Modes/Energy Saver
}
key for three seconds.
Note
❒
0: None, 1: Yes
❒
Default: 0
❒
The machine can not enter the energy saving mode if toner end indicator
lights.
• Screen Message S11): When the copier is idle, the copy counter can
be made to display a message. There are five possible messages: "Pre_heat",
"Sleeping", "0123456789", “Have a good day", and "Hello I love you". This fea-
ture can also be turned off.
Note
❒
0: None, 1: "Pre_heat", 2: "Hello I love you", 3: "0123456789", 4: "Sleeping" ,
5: Have a good day".
• Leading Edge Increase/Decrease Adjustment Preliminary In12):
When changing a function setting (margin, multiple copies, or paper length)
by holding down the
{
+
}
or
{
−−−−
}
key, the setting will change by a preset value.
This value can be changed to 1, 2, 3, or 10 intervals.
Note
❒
0: 3 intervals, 1: 1 interval, 2: 2 intervals, 3: 10 intervals
❒
Default: 0
• Auto Off Time(+15): You can set the time the machine waits after the last op-
eration before switching itself off automatically. The time can be set by
minute from 1 to 240 minutes.
Note
❒
Default: 30min
❒
Auto Off cannot be used in the following cases.
• When the Wait indicator goes on
• When the toner end indicator goes on
• When the front door is open
• While copying
• When a paper misfeed occurs or SC call appears
• The machine cannot enter the Auto Off mode if the roll end indicator
lights while copying repeatedly.
Summary of Contents for LW110
