3/16/2020
www.reddevilsnowblowers.com | Red Devil Snow Blowers
Page | 11
Red Devil Snow Blowers is a registered trademark of Lankota Group.
Preliminary Check
MAKE SURE PTO IS DISENGAGED, ENGINE IS SHUT OFF AND KEYS ARE REMOVED
•
Visually check the shipping pallet and packaging for any shipping damage.
•
Unpack the snow blower from the shipping pallet.
•
Grease all of the grease zerks on your snow blower. (See below drawing)
One on each end of the auger outer bearing holder.
One on the cross drive outer bearing holder.
One on the shear flange sprocket.
Two on chute rotation.
•
Check the chain tension. Adjust idler sprocket if needed.
•
Check the gear box
oil level by removing the fill plug and checking for 9 ounces of oil.
•
Make sure the chute rotation mechanism is working freely.
•
Make sure the deflector mechanism is working freely.
•
Make sure the impeller and auger are free of foreign objects.
•
Make sure all decals and safety signs are clean and readable.
•
Make sure all safety shields are in place and in good condition.
•
Make sure driveline shield spins freely.
•
Make sure the drive line is the proper length for your 3
-
Point setup.
•
Make sure all nuts, bolts, and pins are tightened and secure in place.
•
Make sure the hydraulics are in good working condition by testing each function and checking for leaks.
Use Synthetic 80/90 Gear Oil In Gear Box
