3/16/2020
www.reddevilsnowblowers.com | Red Devil Snow Blowers
Page | 8
Red Devil Snow Blowers is a registered trademark of Lankota Group.
Skid Steer Wiring Installation
-
Solenoid Connections
1.
Connect the 4 connectors shown in Figure 15 and labeled 1
-
4 to the
solenoid receptacles in the hydraulic block of Figure 14.
2.
Pair connector 1 with 2 and 3 with 4 on the solenoids.
Note:
Reconfiguring which ports or solenoids the connectors mate with
will depend on your preference. Switching upper and lower ports within a
pair (ex. 1 & 2) will reverse the switch direction in the cab. Swapping the
pairs with each other (1 & 2 with 3 & 4) will change what a switch in the
cab controls (chute rotation or deflector).
3.
Connect the female end of the harness to either the pin connector
harness or the rocker switch harness.
Figure 15
Figure 14
1
2
3
4
