EM-535 / 6
2.2 J
UMPER
S
ETTING
O
VERVIEW
In order to select the operation modes of your system, configure and set the jumpers on the your SBC
to match the need of your application. To set a jumper, a black plastic cap containing metal contacts
is placed over the jumper pins as designated by the required configuration as listed in this section. A
jumper is said to be “ on ” or “ 1-2 ” when the black cap has been placed on two of its pins, as show in
the figure below:
A pair of needle-nose pliers is recommended when working with jumpers. If you have any doubts
about the best hardware configuration for your application, contact your local sales representative
before you make any changes. In general, you simply need a standard cable to make most
connections.
2.3 I
NSTALLING THE
DIMM M
ODULE
:
A DIMM module simply snaps into a socket on the system board. Pin1 of the DIMM module must
correspond with Pin1 of the socket.
1.Position the DIMM above the socket with the “notch” in the module aligned with the
“key” on the socket.
2. Seat the module at a 90 angle into the bank. Make sure it is completely seated. Tilt
the module upright until it locks in place in the socket.
Pin1
Notch
Key
Summary of Contents for EM-535 Series
Page 4: ......
Page 6: ......
Page 11: ...JUMPER SETTING AND CONNECTORS EM 535 5 PM1 CF REAR SIDE...
Page 20: ...JUMPER SETTINGS AND CONNECTORS EM 535 14 PM1 CF REAR SIDE...
