Page: 34
3.6 Integrated Peripherals
When you select the “INTEGRATED PERIPHERIALS” on the main program, the screen display
will appears as:
Integrated Peripherals Setup Screen
CMOS Setup Utility – Copyright © 1984-2001 Award Software
Integrated Peripherals
Item Help
Menu Level
X
X
X
X
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
USB Controller
USB Keyboard Support
Init Display First
IDE HDD Block Mode
POWER ON Function
KB Power ON Password
Hot Key Power ON
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
ECP Mode Use DMA
PWRON After PWR-Fail
Enabled
Enabled
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Enabled
Disabled
PCI Slot
Enabled
BUTTON ONLY
Enter
Ctrl-F1
Enabled
3F8/IRQ4
2F8/IRQ3
Normal
Half
378/IRQ7
SPP
3
Off
á
â
àß
Move Enter: Select +/-/PU/PD: Value F10: Save Esc: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
On-Chip Primary PCI IDE :
The chipset contains a PCI IDE interface with support for two IDE
channels. Select Enabled to activate the primary IDE interface. Select Disabled to deactivate this
interface. The settings are “Enabled” and “Disabled”.
On-Chip Secondary PCI IDE :
The chipset contains a PCI IDE interface with support for two
IDE channels. Select Enabled to activate the secondary IDE interface. Select Disabled to
deactivate this interface. The settings are “Enabled” and “Disabled”.
IDE(Primary / Secondary)(Master / Slave) PIO :
The four IDE PIO (Programmed
Input/Output) fields let you set a PIO mode (0-4) for each of the four IDE devices that the
onboard IDE interface supports. Modes 0 through 4 provide successively increased performance.
In Auto mode, the system automatically determines the best mode for each device. The settings
are “Auto”, “Mode 0”, “Mode 1”, “Mode 2”, “Mode 3”, “Mode 4”.
Summary of Contents for EM-561 Series
