Page: 35
IDE Primary / Secondary Master / Slave UMDA :
Ultra DMA/66 implementation is possible
only if your IDE hard drive supports it and the operating environment includes a DMA driver
(Windows 98 OSR2 or a third-party IDE bus master driver). If your hard drive and your system
software both support Ultra DMA/66, select Auto to enable BIOS support.
The settings are
“Auto” and “Disabled”.
USB Keyboard Support :
Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have a USB keyboard.
Init Display First :
This item allows you to decide to active whether PCI Slot of VGA card or
AGP first. The settings are “PCI Slot” and “AGP Slot”.
IDE HDD Block Mode :
Block mode is also called block transfer, multiple commands, or multiple
sector read/write. If your IDE hard drive supports block mode (most new drives do), select
Enabled for automatic detection of the optimal number of block read/writes per sector the drive
can support. The settings are “Enabled” and “Disabled”.
Power On Function:
this function allows you to select the item to power on the system. The
settings are: Button Only, Mouse Left, Mouse Right, Password, Hotkey, and Keyboard98.
KB Power On Password:
Normally, this item is unselectable. To enable this function, choose
the “Password” setting in
POWR ON Function.
This will allow you to input the password for the
KB power on function.
Hot Key Power On
: If POWER ON Function is set to “Hot Key”, and then you can assign a hot
key combination in the field for the PS/2 keyboard to power on the system. Available options are
“Ctrl-F1” through “Ctrl-F2”.
Onboard FDC Controller :
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install an add-in FDC or the system
has no floppy drive, select Disabled in this field.
Onboard Serial Port 1 / 2:
Select a logical COM port address for the first and second serial
ports.
UART Mode Select :
The UART serial port on your system may offer a variety of infrared port
modes. Click here for a description of various modes. (Click your browser’s Back button, or your
right mouse button, to return to this page).
UART 2 Duplex Mode:
This item allows you to select the IR half/full duplex function. The
default setting is “Half”
Onboard Parallel Port :
This item allows you to determine onboard parallel port controller I/O
address setting. The settings are “378H/IRQ7”, “278H/IRQ5”, “3BC/IRQ7”, “Disabled”.
Parallel Port Mode:
There are four options “Normal” (default), “ECP”, “ECP/EPP” and “EPP/SPP”.
Change the mode from “Normal” to the enhanced mode only if your peripheral device can
support it. When it is set to ECP mode, the printer port always uses DMA3.
ECP Mode Use DMA :
Select a DMA channel for the parallel port for use during ECP mode.
The settings are “3” and “1”.
PWRON After PWR-Fail:
This item allows you to determine how the system will power on after
a power failure.
Summary of Contents for EM-561 Series
