AWARD BIOS SETUP
~34~
IR Function Duplex :
This item allows you to select the IR half/full duplex function.
TX, RX inverting enable :
This item allow you to enable the TX, RX inverting which
depends on different H/W requirement. This field is not recommended to change its
default setting for avoiding any error in your system.
Onboard Parallel Port :
This item allows you to determine onboard parallel port controller
I/O address setting. The settings are “378H/IRQ7”, “278H/IRQ5”, “3BC/IRQ7”,
“Disabled”.
Onboard Parallel Mode :
Select an operating mode for the onboard parallel (printer) port.
Select “Normal”, “Compatible”,
or “SPP” unless you are certain your hardware and
software both support one of the other available modes.
ECP Mode Use DMA :
Select a DMA channel for the parallel port for use during ECP
mode. The settings are “3” and “1”.
Parallel Port EPP Type :
Select EPP port type 1.7 or 1.9.
