Install Applicable Model Onto the Rack
Reminder: it is strongly recommended to carry out this
procedure with two or three persons.
1. Hold the applicable model with its front facing you, lift
the chassis and gently insert the model by aligning with
the slide-rail assemblies, as shown in the image below.
Then push the model as far as possible.
2. Simultaneously push the release tabs on both sides in
the arrow of direction below, while pushing the appliance
into the end of the rack.
Caution: the appliance will be locked during the half way
of sliding-in if the release tabs are not pushed.
3. Completed.
4. To slide the appliance out, gently pull it outwards.
Then, press the slide-rail locks on both side and slide the
appliance out.
Notes: the process of sliding-in and sliding-out should be
smooth. If not, please adjust the mounting tips.
