Appendix A Watch-Dog Timer
37
User’s Manual
APPENDIXA. Watch-Dog Timer
You can enable the watch-dog when your application software monitors an unexpected or not respond,
then the timer generates a reset to reboot your system. During the period of enable to reset, you
could still cancel reset by disabling the watch-dog. Decide the way you want to set the period for
reset by selecting hardware or software watch-dog (if both of them are available). Software setting
period, normally setting watch-dog timer period to 16 level.
Software watch-dog using example
EX.1: For DOS
Enable
Disable
C:\DOS> DEBUG C:\DOS>DEBUG
-o443
D -o441 F
EX.2: For assemble Language
Enable : Disable :
MOV DX, 443H MOV DX, 441H
MOV AL, 0FH MOV AL, 0FH
OUT DX, AL OUT DX, AL
Note: “F” is the period of software watch-dog timer (normally “F” indicated 0 sec.). 0 to 9
and A to F are used for represent different period. Normally, the step is 2 sec. That
means “E” is 2, “D” is 4, “2” is 26, “1” is 28 and “0” is 30 seconds.
Summary of Contents for IAC-H488 Series
