Chapter3 BIOS Setup
31
User’s Manual
AGP Master 1 W / S Write:
Implements a single delay when writing from the AGP Bus. Normally, two
wait states are used, allowing for greater stability.
AGP Master 1 W / S Read:
Implements a single delay when reading from the AGP Bus. Normally, two
wait states are used, allowing for greater stability.
PCI Delay Transaction:
Choose the "Enabled" option to obtain higher PCI bus performance for slower
ISA bus application.
ISA Bus Clock:
Allows you to set the speed of the ISA bus in fractions of the PCI bus speed
USB Controller:
This option will enable on-chip USB controller to support USB (Universal Serial Bus)
peripheral devices if user chooses the "Enabled" setting.
USB Device Legacy Support:
This field support Universal Serial Bus (USB) devices. If detected, USB
controller legacy mode will be enabled. If not detected, USB controller legacy mode will be disabled.
Port 64/60 Emulation:
Setting this option to allow a USB Keyboard to act like a legally keyboard.
OnChip VGA Frame Buffer Size:
This option help you to use a VGA frame buffer and 16 Mb of RAM at the
same time; the system will allow access to the graphics card through a hole in its own memory map; in
other words, accesses made to addresses within this hole will be directed to the ISA bus instead of main
memory.
LCD Panel Type:
This option specifies the resolution and the type of LCD panel.
Summary of Contents for IAC-H671 Series
Page 2: ......
Page 4: ......
Page 6: ......
Page 9: ...Chapter1 Introduction 3 User s Manual 1 5 Board Layout...
