Chapter3 BIOS Setup
39
User’s Manual
3.11 Change User/ Supervisor Password
When you select this function, a message as below will appear on the screen:
AMIBIOS HIFLEX SETUP UTILITY - VERSION 1.54
© 2001 American Megatrends, Inc. All Rights Reserved
Standard CMOS Setup
Advanced CMOS Setup
Advanced Chipset Setup
Power Management Setup
PCI / Plug and Play Setup
PCI / Plug and Play Setup
Peripheral Setup
Hardware Monitor Setup
Auto-Detect Hard Disks
Change User Password
Save Settings and Exit
Exit Without Saving
Change the user password
ESC : Exit
↑↓
: Sel F2/F3 : Color F10 : Save & Exit
AMIBIOS HIFLEX SETUP UTILITY – VERSION 1.54
© 2001 American Megatrends, Inc. All Rights Reserved
Standard CMOS Setup
Advanced CMOS Setup
Advanced Chipset Setup
Power Management Setup
PCI / Plug and Play Setup
PCI / Plug and Play Setup
Peripheral Setup
Hardware Monitor Setup
Auto-Detect Hard Disks
Change User Password
Save Settings and Exit
Exit Without Saving
Change the supervisor password
ESC : Exit
↑↓
: Sel F2/F3 : Color F10 : Save & Exit
Type the password, up to six characters in length, and press<Enter>. The password typed now will replace
any previously set password from CMOS memory. You will be prompted to confirm the password. Retype
the password and press<Enter>. You may also press<Esc> to abort the selection and not enter a
password.
To clear a set password, just press<Enter> when you are prompted to enter the password. A message will
show up confirming the password will be disabled. Once the password is disabled, the system will boot and
you can enter Setup without entering any password.
When a password has been set, you will be prompted to enter it every time you try to enter Setup. This
prevents an unauthorized person from changing any part of your system configuration.
Additionally, when a password is enabled, you can also have AMIBIOS to request a password each time the
system is booted. This would prevent unauthorized use of your computer. The setting to determine when
the password prompt is required is the PASSWORD CHECK option of the ADVANCED BIOS FEATURES menu.
If the PASSWORD CHECK option is set to Always, the password is required both at boot and at entry to
Setup. If set to Setup, password prompt only occurs when you try to enter Setup.
Note: About Supervisor Password & User Password
Supervisor Password : Can enter and change the settings of the setup menu.
User Password
: Can only enter but do not have the right to change the settings of the setup menu.
Enter new user password:
Enter new supervisor password:
Summary of Contents for IAC-H671 Series
Page 2: ......
Page 4: ......
Page 6: ......
Page 9: ...Chapter1 Introduction 3 User s Manual 1 5 Board Layout...
