08
● ● LP-1540ai ● User Guide
▪
In regard with data wiring, in this type of powering connection,
a data cable must be installed between the LP-1540ai and the
corresponding data outlets. In this document in Router mode, both
(LAN y WAN) ports must be connected to the corresponding points:
▪
In regard with data wiring, in this type of powering connection,
a data cable must be installed between the LP-1540ai and the
corresponding data outlets. In this document in Router mode, both
(LAN y WAN) ports must be connected to the corresponding points.
▫
From the LP-1540ai LAN port to the internal LAN Switch or the
PC’s Ethernet port, or to the serviced equipment.
▫
From the WAN port of thel LP-1540ai to the Switch or ADSL
providing the internet connection.
Figure 2.
Figure 3.
●
If you plan to power your LP-1540ai up with the non-standard PoE
injector, please take in mind any distance limitation imposed by
losses in the cabling used. A rule of thumb when not sure enough
is to limit the distance to 80m, this supposes the use of good wiring
standards of workmanship and the following of the local standards.
