www.lanpro.com
Wireless - Equipment - 5.8 GHz - LP-5a Setup 123 Manual
3
4
Figure 7
Figure 8
Proceed to join the bases and insert the corresponding screws and washers, as shown in figures 7 and 8.
c
Cable preparation for powering the LP-5a with PoE injector.
Antenna connection. Fix the antenna as shown in the antenna instructions. Use the proper RF cable, screw the antenna
connector to a surge arrester like the LP-G11 from LanPro, and continue from the surge arrester to the LP-5a N connector
with another RF cable. Figures 10 show the details.
The recommended cable is the LP-214502 Outdoor Cat5e Cable by LanPro, and should be prepared as per the proper
wiring standard used in the downstream hardware. If grounding standards are stringent, cable should be of the braided
type and the braid connected at the shielded RJ-45 plug.
Figures 9a and 9b show the two possible schemes used for sealing the RJ-45 connector against moisture.
Figure 9a
Figure 9b
Figure 10
a
3
