www.lanpro.com
Wireless - Equipment - 5.8 GHz - 123 Manual for Installing the LP-5ai in AP Mode
2
The following Instruction Manual will guide you on how to configure the LP-5ai in AP Mode.
Figure 1
1
2
3
Once the Setup 123 Manual, document
LP5AI_M123_
END01W.pdf has been executed, proceed to configure it by
first connecting the UTP cable that goes from the LP-5ai to
the To ODU port of the PoE Injector furnished with the radio,
as shown in figure 1.
Connect an UTP cable from the To Ethernet port of the PoE
injector to the Switch or PC as shown in figure 2.
Figure 2
4
Connect electric power to the PoE injector as shown
in figure 3.
Please go to your network card properties window and
select:
Internet Protocol
, then select:
Properties
, as
shown in figure 4.
Figure 3
Figure 4
