LPF30F_UG_ENB01W
www.lanpro.com
Step 1:
Pull the boot
and ring out from the
LP-F30F connector.
Step 3:
Press the LP-F30F tool to release the cable and check if they are the same
as the chart shows. If it is the same, install the connector again. If the length
between marks becomes shorter, broken fiber might be stuck inside the connector.
This connector can not be used anymore.
Step 2:
Put the
connector into the
LP-F30F tool, tape
the connector.
Step 4:
Restart the
installing process.
reset the SC Field Installable
LP-F30F Connectors (2.0/3.0 mm type)