4
E N G L I S H
3
E N G L I S H
3
– How to Clean and Sterilize Your Lansinoh Manual Breast Pump:
Sterilize:
Prior to using your pump for the first time, disassemble it (remove silicone diaphragm and
stem, ComfortSeal
TM
cushion, white valve and separate bottle, cap and sealing disk) and
boil all parts for 10 minutes. Remove all parts from water immediately after boiling.
Completely air dry before assembly and before the next use.
Cleaning:
The breast flange, bottles, handle and flange cover/bottle stand may be cleaned in the
upper compartment of your dishwasher or hand washed with dish soap and hot water. For
best results when hand washing the pump, we recommend using the cleaning brush to
thoroughly clean your breast flange. Do not use solvents or abrasives. Rinse with hot,
clean water.
The white valve, silicone diaphragm and stem and the ComfortSeal
TM
cushion can be
washed in the dishwasher; however, we recommend washing them by hand to prevent loss
and to extend their usefulness.
Completely air-dry all parts on a clean towel or drying rack.
NOTE: Use caution when cleaning the small white valve. It is important for proper suc-
tion. Do not use excessive force and do not clean with a baby bottle brush, a nipple brush
or the cleaning brush included with your pump. Gently wash by hand in hot soapy water
and rinse under hot running water.
4
– How to Assemble Your Lansinoh Manual Breast Pump:
Prior to assembling your Lansinoh Manual Breast Pump ensure that all parts have been
cleaned and sterilized as detailed in section 3 of this manual.
1
- Wash your hands thoroughly.
2
- Gently secure the white valve onto the
breast flange from underneath making
sure the white valve is flush with the lip of
the breast flange. It is not necessary to
use excess force when applying the white
valve. If you find that the white valve is
difficult to remove, you have pushed it too
far onto the breast flange.
3
- Screw the bottle onto the breast flange.
4
- Place the silicone diaphragm and stem
on top of the breast flange. Make
sure it fits securely around the rim by
pressing down with your fingers to
ensure a perfect seal. *
5
- Place the forked end of the handle
under the diaphragm stem and push
down gently on the handle until it clicks
into place.
6
- Carefully insert the ComfortSeal
TM
cushion into the funnel of the breast
flange making sure it is perfectly sealed
around the rim of the funnel. *
7
- To make the pump completely stable,
insert the bottle into the bottle stand.
Or, when not in use, the bottle stand can
be used as a cover over the breast flange
(flange cover).
8
- When fully
assembled,
this is what
your pump
should look
like.
* These parts are designed to fit
snugly. For easier assembly, just
dampen the rim of the silicone
diaphragm and/or ComfortSeal
TM
Cushion with water.
