Lansinoh Smartpump, Instructions For Use Manual

12

13

3.

  Insert pump connector into opening 

on left side of pump.

1.

  Secure one end of 600 mm 

tubing to Tubing Y Connector.

2.

  Secure other end of 600 mm tubing 

firmly to the pump connector.

4.2 Connecting the Breastmilk Expression Set

Once Breastmilk Expression Set is assembled, connect to pump base:

4.3 Connecting for Single Pumping

1.

  Remove one of the 300 mm  

tubing from the Tubing Y Connector.

2.

  Secure plug into open outlet of  

Tubing Y Connector.

5. USING THE LANSINOH SMARTPUMP DOUBLE ELEC-

TRIC BREAST PUMP

5.1 Power Options

The pump may be operated using the following power supply modes:

AC Adapter

1.

  Connect the AC adapter to the power 

receptacle located on the right side of 

the pump. Plug the AC adapter into an 

available electrical outlet. 

2.

  Electrical safety can only be achieved 

when the breast pump is connected to 

the AC Power adapter supplied with the 

product. (See “Technical Data” section, 

page 21)

AA Alkaline Batteries (not included)

1.

  Make sure the batteries are inserted correctly 

according to the polarity (+) and (-) as indicated. 

2.

  Close the compartment by gently pressing  

the cover until it snaps into place. 

●

   Remove batteries if pump is not in use for a long period of time. 

●

   Dispose of batteries according to regulations for environmental 

protection and recycling. 

●

   Replace batteries as a simultaneous set. Do not mix old and  

new batteries. 

●

Do not mix alkaline and standard (carbon-zinc) batteries. 

●

   If batteries are in the pump, but AC adapter is in use, the pump will 

use the adapter to power the pump, not the batteries.

For the most economical use, we recommend using your pump with the AC adapter 

provided. Your AC adapter is a universal AC plug adapter type and can be used with 

100 Vac to 240 Vac systems with 50Hz and 60Hz mains.