© Lanta Lighting™ 2011. Terms Apply. All trademarks are the property of their
respective owners. E&OE. All specifications and details are correct at time of print.
Revision 1
Fireball Par64S Owner Handbook ™
Operation of the Lanta Fireball Galaxy Pro™
To select the various different modes of operation, there is a 4 button keypad and 4 digit
LED display on the rear of the product.
To begin, press the button marked “MODE”. Each press will choose one of the working
modes described below. Once the desired mode has been selected, the button marked
“SETUP” will allow the user to select a parameter that they wish to change (such as speed
etc). To choose a value of the parameter, press either the “UP” or “DOWN” buttons until
the desired setting is achieved.
Note:
There is no need to have an “enter” or “store” button, as this is automatically done
for you.
Note: The LED display will enter power saving mode after 20 seconds after the last button
press. It will turn on again after pressing any button.
Note: When first powered on, the display will briefly show the firmware version programmed
into the memory of the controller. This is displayed as a “U” followed by the version number.
(e.g. “U3.01”)
1- Built-in PROGRAM Mode (Single pattern)
To use the built-in program mode – a library of exciting and vibrant patterns and colour
changes, keep pressing the “MODE” button until the LED display shows “PR” followed by a
2-digit number (e.g. PR07). The “UP” and “DOWN” buttons allow the selection of a pattern
and there are more than 20 patterns to choose from.
When you have selected the pattern you desire, you have the option of changing the
speed of the program – i.e. how fast the different colours and patterns appear. To change
the speed, press the “SETUP” button then use the “UP” and “DOWN” buttons to select the
desired speed.
